Possible Issues

Metric Displays “N/D” or “Wthr?”

The “No Data” message will display if data was currently unavailable for this metric. This could happen for a variety of reasons, and it’s likely only temporary.

For example, if this is a metric reported by a local weather station, and equipment malfunction at the weather station may prevent this information from being available to Garmin and, by extension, your watch face.

If the metric is in an On-Device Complication (ODC) slot, then you could see the “N/D” error if the app that publishes this metric has not been started or run since the watch was started or the app was downloaded. To resolve this, you can use the Hold-to Open (HTO) feature to activate the app or widget by touching and holding the location of this metric on your watch face. Once you open the app or widget, it should begin publishing data shortly. Then, when you return to your LuxeLion watch face, you should begin to see data in the right spot.

Another example would be if your metric is “Respiration Rate” and your watch couldn’t calculate a valid value. That could occur because the watch is not on your wrist, too loose on your wrist, or just because… In any event, once the information becomes available again, the data should come through again.

In general, your watch is indicating that it just doesn’t have this value available to display.

To resolve this message, you can wait a while and see if it resolves itself. Otherwise, select another metric that is available.